Frequently Asked Questions

Check most frequently asked questions here, if you still need help then please contact us at info@growthchartfun.com.

General

  • Measure from the ground UP 18" and make a light mark with a pencil. (This will be the bottom of the banner once hung).

  • If you are measuring for the Hanging Teak banner…With the nail through the leather string, hold it up until the bottom of the banner is level with your pencil mark at the bottom.

  • Hammer the nail in, and you're ready to have GROWTH CHART FUN with the whole family.

How to measure the height

Hanging Teak

  • Any small, or decorative nail of your choice.

  • A small hammer.

  • A tape measure.

Peel & Stick

Our Growth Chart Fun Peel and Stick decals work best on the following surfaces:

  • Paint
  • Metal
  • Sanded wood without Lacquered drywall (allow 30 days after painting)
  • Glass
  • Non-Textured or Non-Porous Wall
  • Freshly painted surfaces less than 30 days.
  • Matte or Flat Paint
  • Heavy Textured
  • Brick / Cinder Block
  • Porous Textured wood or Paneling
  • Outside in a non-temperature controlled Environment

We recommend having a helper with you to make the installation a bit smoother. Decals as large as these are sometimes difficult to hang by yourself.

Step 1

  1. Open the Package and lay the Decal face down and allow it to relax for an hour minimum.
  2. Review any enclosed information.

Step 2

  1. Pick a spot for your Growth Chart Fun decal.
  2. Take a moment to view and measure the area. (It's a good idea to hold up the decal to the spot and make sure it is centered and level).
  3. The Growth Chart Decal adheres best to clean, smooth, indoor surfaces.

Step 3

  1. Clean the surface. Use a warm damp cloth to wipe down the designated area.
  2. Allow it to dry completely.
  3. Do not use soaps or cleaning agents, they cause the decal to not adhere in-properly.

Step 4

  1. Lay the decal face down on a flat surface.
  2. Start at the top of your decal and SLOWLY peel the backing.
    **DO NOT!  allow the decal to touch itself. (I repeat DO NOT! You will be cursing. BE PATIENT and go slow) It will pay off in the end.**
  3. Place one corner of the decal down and gently smooth the rest of the top into place using minimal pressure.
  4. If it doesn’t look or feel right, gently peel the decal off the wall and reposition it. (Take your time it will look great.)
  5. Larger decals come with a plastic squeegee to help remove the air bubbles/ wrinkles.
  6. Start to squeegee gently from the middle out to the edges. (Old t-shirts, soft cloths, towels, etc. work great also)